Rear Panel - Skytec 172.564 Mode D'emploi

REAR PANEL

46. POWER JACK
Mains power inlet.
47. MAINS SWITCH
Press this button to switch the mixer ON or OFF. The LED (29) lights up when this switch is in ON
position.
48. INSERT
To feed the input signals into effect units, electrical instruments, etc.`
INSTALLATION
Do not mix up the cable in order to avoid wrong connections. Connect the leads one by one and not all
leads on one side first and then all on the other side. In the worst case, you might permanently
damage the unit. Figure 2 shows an example of possible connections.
Prior to connecting the mixer, set all controls to "0". You can connect microphone or line units to the
mono channels, all kinds of line units to the stereo channels and effect units to the AUX Return. You
can also connect Midi instruments to the AUX Return.
If you connect a microphone, make sure that the phantom power is switched OFF. DO NOT use
unbalanced units when the phantom power is switched on. Do not short-circuit the 48V circuit of the
phantom power to the ground. You might heavily damage the unit.