Publicité
Les langues disponibles
Les langues disponibles
Parts of the packaging (e.g. foil, styropor) may be dangerous
for children. Risk of suffocation! Keep these parts of the
packaging out of reach of children and dispose as soon as
possible.
In the EU, this symbol refers to the fact the given
product is not allowed to be disposed as
household waste. Old appliances contain
valuable materials that can be recycled and you
should take them to a collection point to prevent
any damage to the environment and human health by
uncontrolled waste disposal. Therefore, dispose any old
appliances through collection points or send them for disposal
to where you have bought them. By this, some materials from
these appliances will be reused.
Operator Requirements
The operator shall read the instruction manual carefully
before using the unit.
Qualification
No special qualification is required for use of the unit except
for detailed direction by a professional.
Minimum Age
Only persons above 16 years of age are allowed to work with
the unit. Exempted from the provision is the use of the
juvenile trainees if they work in the course of their
professional training with an aim to obtain the skill under
trainer supervision:
Training
Use of the unit requires adequate lesson by a professional or
the use of the manual only . Special training is not required.
Technical Data
Connector:
Charging voltage at start:
Charging rms current:
Charging arithmetic current:
Starting current app.:
Max. input:
Min. protection:
Rated capacity:
Battery start:
Weight:
Dimensions (mm):
Transportation and Storage
•
If putting the unit away for a prolonged storage, it should
be cleaned thoroughly.
•
Protect the unit from weather effects with a tarpaulin,
carton etc.
Assembly and Initial Operation (Fig. 4+5+6)
Screw on the handle according to (Fig. 5).
Put the axle through the charger (Fig.1/2). Fit the supplied
safety rings on. Mount the wheels (Fig.1/1) on the axle and
secure them with safety rings (Fig .6).
Put the wheels covers on.
Screw on the foot (Fig. 1/4) using the supplied screws
(Fig.1/3).
230 V/50-60 Hz
12V / 24 V
60 A
40 A
0 V: 390 A
1.5 V: 240 A
8 kW
16 A
20-1000 Ah
35-50 Ah (without
previous charging)
65-100 Ah (with previous
charging)
16 kg
330 x 250 x 600
Operation
Unplug before any adjustment and set up.
Charging (Fig .3)
•
Connect the charger to the battery to be recharged
•
Always connect the black cable first, to the negative pole.
Connect the red pole cable to the positive pole.
The battery should be completely disconnected from
the vehicle before getting down to charging.
•
Always set the charger at the lowest charging degree
(min/1) (Fig.3/8)
•
Now, plug in and control the charging degrees upwards
until charging current equal to ca 10% of the battery
capacity is displayed.
•
Charging degrees may be increased by falling charging
current. (Fig.3/7)
•
Do not disconnect the battery from terminals later than
3-5 hours after charging is finished.
•
Notice. The charging current indicator will not
come back to zero after charging is finished.
Charging Time
•
The charging time always depends on the battery status
(nearly charged, half-charged or completely discharged)
•
To recover a battery that is normally in use 2 – 4 hrs are
sufficient, while for full recharging 8-10 hrs are needed.
•
Charging time should not be exceeded (10 hrs
max.).
Start-up Assistance
•
CAUTION! At the startup process can overvoltages
arise, the on-board electronics could damage their
vehicle. Please discuss with your automotive specialist.
•
Connect the batteries as shown in part "Charging" and
leave it connected to the vehicle!
•
On principle, two persons should always start up a
vehicle with chargers.
•
The charger on max. Performance are:
Switching stage 2 (Fig. 3/7) and "BOOST" (Fig. 3/8).
•
The first person shall push the Start button on the
charger (Fig. 3/9). The other one shall immediately start
the ignition, max. 9-10 sec.
•
As the vehicle starts up, stop starting immediately
•
If the attempt to start fails, wait about 5 minutes for the
charger to get cooled and only then begin another
attempt to start.
Tip: If you change the battery for 10-15 minutes to
subpoena requires much less battery power startup.
Warning: The fuses may burn through and the
vehicle damaged if the starting time is more than 10 s.
Note: The terminals may not touch.
Notice: The charger is equipped with overload
protection.
Important: A change of drop-out fuses for fuses (pic. 3/5)
not corresponding to fuses in the appliance can cause
material damage or injury of persons.
Change the drop-out fuses only when the power cord is
unplugged!
Operator Safety Instructions
•
Any safety and protection devices must be fitted in
place before switching the unit on.
•
It is forbidden to attempt starting vehicles, the batteries
of which are discharged or damaged as that would
result in damaging the unit.
10
Publicité
