HQ Power PROMIX400U2 Notice D'emploi page 4

• Always begin with the master faders, volume controls and the amplifier volume at minimum position.
Gradually turn up the volume after connection is completed.
• Use the controls with restraint. Rapid movements may damage the speakers due to amplifier clipping.
• Use the original packaging if the device is to be transported.
• Keep this manual for future reference.
4. Features
• outputs: 2 Master (XLR and RCA), 1 Rec (RCA) and booth monitor output (RCA)
• inputs: 2 Phono (RCA), 4 Line (RCA) and 1 MIC (Combi), USB
• with Digital Signal Processor (DSP) effects and fader start control
• trim: gain for each input channel
• peak level meter: allows the user to instantly determine the source input condition for each channel
• talk over: mutes -14dB all levels apart from the microphone MIC1
• cross fader curve: choose from two types of cross fader start-up options
• headphone monitor balance between cue and master out
• freely assignable long life TCT cross fader (45mm) with adjustable curve
• extra LED display per channel for pre-listening signal
• gain control with 3-fold sound control (+12/-26dB) per channel
• 3-fold sound control (+12/-26dB) for microphone
• CUE on and off switch for each channel
• cue-split function: the cue signal is sent to one side of the headphones and the output-signal to the
other side.
5. Overview
Refer to the illustrations on page 2 of this manual.
1 power switch: turn the mixer on or off.
3-pin XLR connection for main microphone (not included)
2 MIC LEVEL: adjust the microphone input level
HI/LOW: microphone equalizer
Input channel controls (CH-1 ... CH-4)
Input selector switches:
• Channel 1-2: LINE or PHONO. Set to PHONO if a turntable (not incl.) is connected to the input;
otherwise set to LINE.
• Channel 3: LINE or USB. Set to USB if an input device is connected via the USB port [24]; otherwise
set to LINE.
3
• Channel 4: LINE or MIC. Set to MIC if a microphone (not incl.) is connected to the input; otherwise
set to LINE.
TRIM: adjust the input signal level
HI/MID/LOW: channel equalizer
Peak level meter
Master channel
4
LED meter: indicates the master output level
TALK OVER: press this button to decrease the sound level for everything other than the main
5
microphone to 14dB. Press again to restore original status.
CUE: press this button to monitor the channel with headphones. You can select multiple channels at
6
once, including the master channel and the DSP effects. Press again to cancel the selection.
V. 02 – 09/03/2012
PROMIX400U2
4 ©Velleman nv