Clean The Tacky Rollers - Rimage Everest Manuel D'utilisation

Clean the tacky rollers

Before you begin:
Power off the printer.
1. Remove the print ribbon. For specific
instructions, refer to page 20.
2. To access the tacky rollers, remove
the supply roll (the unused portion) of
the print ribbon from the print ribbon
carrier.
3. Clean the tacky rollers.
a. Apply isopropyl alcohol to the
sponge swab.
b. Use the sponge swab to clean
tacky roller 1.
c. Use the sponge swab to remove
any waxy buildup from other parts
of the ribbon carrier.
d. Reinstall the supply roll on the
print ribbon carrier.
e. Inside the printer, use the sponge
swab to wipe tacky roller 2.
4. Prepare the printer for use.
a. Install the print ribbon carrier.
b. Close all latches.
c. Close the side cover.
d. Power on the printer. The printer
is ready.
110632_L
Maintain the Everest printer
Ribbon
carrier
Ribbon carrier
Tacky
roller 1
Tacky
roller 2
25