Changing The Print Ribbon - Rimage Everest Manuel D'utilisation

Rimage Everest Printer

Changing the print ribbon

Before changing the Everest print ribbon, allow time for the new ribbon to become acclimated to
the environment. Allow more time for greater temperature and/or humidity differences.
Important! Ribbons must be stored at a temperature between 50°– 90°F (10–32°C). Avoid
moisture and direct sunlight. Do not reuse ribbons.
Before you begin:
Power off the printer.
1. Remove the print ribbon.
a. Press the two cover latches to
release the side cover.
b. Lower the side cover.
c. Turn latch 1 counter-clockwise.
d. Remove the print ribbon
carrier.
e. Remove the print ribbon from
the carrier.
2. Discard the used print ribbon.
Tip: Perform cleaning
procedures while the print
ribbon is removed. Refer to
'Cleaning the Everest printer' on
page 24.
20
Side cover
Print ribbon carrier
Cover latches
Latch 1
110632_L