Control Panel - Rimage Everest Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 119
Rimage Everest Printer

Control panel

The control panel, located on the front of the printer, includes an operator button
and four indicator lights. The control panel allows you to monitor and control the
Everest printer.
Tip: If all indicator lights are blinking, the printer did not initialize properly. To
correct this issue:
1. Remove the power cord. The Everest printer powers down.
2. Set the mode switch to the proper position. For more information, refer to
the table on page 6.
3. Reconnect the power cord. The Everest printer powers on.
Image
Name
Operator Button
Error indicator light
CD Present indicator light
Active indicator light
Power indicator light
4
Functionality
The operator button is used to complete the
following tasks:
• Open the printer drawer
• Close the printer drawer
• Reset after an error
• Put the printer in sleep mode
Tip: To put the printer into sleep mode, press
and hold the operator button for 10
seconds. Press the operator button again to
resume normal operation.
The error indicator light, located on the operator
button, illuminates when operator action is required.
The CD present indicator light illuminates when a
CD is placed on the drawer or when the CD is
properly clamped.
The CD present indicator light flashes when an
Everest print latch is open or a ribbon is not
detected.
The active indicator light illuminates when the
printer has completed initialization.
The active indicator light flashes when the Everest
printer is receiving data from the host.
The power indicator light illuminates when the
Everest printer is powered on.
110632_L

Publicité

Table des Matières
loading

Table des Matières