Makita 2416S Manuel D'instruction page 5

Positioning the spark chute
► 1. Spark chute 2. Base top 3. Point A
To prevent sparks from flying around, raise the spark
chute slightly so that point A will be below the base top
indicated.
CAUTION:
• Be sure to adjust the spark chute as mentioned
above before operation. Failure to do so will
cause more sparks to fly around causing greater
potential for injury or ignition of any combustible
materials nearby.
Adjusting stopper plate
The stopper plate prevents the wheel from contacting
the surface of the bench floor.
1. When the new wheel is installed, set the stopper
plate as shown in the figure and tighten the thumb
bolt.
1
► 1. Thumb bolt 2. Stopper plate
2. When the wheel wears down to below 355mm
(14" ) in diameter, set the stopper plate as shown
in the figure and tighten the thumb bolt.
1
2
3
3. When the wheel wears down to below 305mm
(12") in diameter, set the stopper plate as shown
in the figure and tighten the thumb bolt.
Changing the width between vise
and guide
2
2
► 1. Socket wrench 2. Guide 3. Hex bolt 4. Vise
Changing guide position to accommodate larger work-
piece as shown, the socket wrench can be used to
remove the hex bolts and move the guide. The following
interval settings are possible:
0-170 mm (0 - 6-3/4")
60-230 mm (2-3/8" - 9")
5 ENGLISH
3
1
4