Installation; Sauna Heater Installation - Tylo Sense U 7 Elite Notice D'installation Et D'utilisation

6
Typical wall construction
Figure 8: Typical wall construction

INSTALLATION

Sauna heater installation

It is easiest to prepare for installation with the heater lying down.
To install the heater:
1. Lay the heater down with the front facing upwards.
2. Undo the screws and open the cover (see Figure 9).
Figure 9 Opening/closing the cover
WARNING! Always check that the heater is con-
nected to the correct main/phase voltage!
Connect the heater using 90°c approved rated wire for fi xed
installation. Installed shall be inaccordance with NEC and State
and local codes.
3. Connect the electrical cable (1) to the terminal (2) (see Figure
10) according to the wiring diagram (see the Connection/wir-
ing diagram section, page 8).
4. Run the cables for the control panel and the temperature
sensor through the cable grommets (3). Connect the control
panel cable (4) to one of the four RS485 contacts (positions
5-8 Pure, 6-9 Elite) (see Figure 10) according to the wiring
diagram (see the Connection/wiring diagram section, Fig18
page 8).
5. Connect the humidity- and temperature sensors cable (6) to
one of the four RS485 contacts (positions 5-8 Pure, 6-9 Elite)
(5) according to the wiring diagram (see the Connection/wir
ing diagram section, Fig. 18 page 8).
6
11
5
7
Figure 10: Circuit board
1. Electrical cable
2. Terminal for connection of elec-
trical cable
3. Cable grommet (x6)
4. Control panel cable
5. Modular contacts for connection
of control panel, sensor etc.
6. Sensor cable
6. Connect the light cable (if used) (7), see Figure 10, to the
terminal (8) according to the wiring diagram Figure 18.
7. Close the cover and tighten the screws (see Figure 9).
NB: If all the screws on the back are unscrewed
simultaneously, the back plate may come loose.
For this reason, attach the four brackets to the
heater one at a time.
8. Unscrew the fi rst two screws on the back of the heater and
screw one of the four brackets into place. Repeat the proce-
dure until all of the brackets are fi tted see Fig. 11.
Figure 11: Attaching the brackets to the heater
9. Position the bracket screws according to the specifi ed dimen-
sioning see Fig. 12.
4
9
3
1
10
2
8
7. Light cable (if connected)
8. Terminal for connection of
light (if connected)
9. Strain relief connector for
cables to modular contacts
(x2)
10. Strain relief connector for
electrical cable
11. Protection hose for RJ10
cables