Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION GUIDE
BEFORE INSTALLATION
Parts
Check that the following parts are included in the packaging:
1
4
2
3
5
6
7
8
Figure 1: Sauna heater/control panel parts
1.
Sauna heater
2.
Herb bowl/air humidifi er
3.
Brackets x 4
4.
Lock screw B8x9.5 x 1
5.
Warning and Caution plates for the room in multiple languag-
es
6.
Screws B 4 x 6.5 x 6 for Warning and Caution plates
7.
Connectors x 3
8.
Bracket screws x 4
9.
NTC Sensor, cable length 4 m
10. Clips TC (3-5) x 10 pieces
11. Plastic plugs 25x5 x 2 pcs
12. Screws B6x25 x 2 pcs
13. Screw B4x6,5 x 1 piece
14. Sensor cover
15. Rock guard
16. Protection hose Ø14x150 mm x 3 pcs, for RJ10 cables (sen-
sor, control panel, door switch)
Contact your dealer if anything is missing.
9
12
10
11
14
13
15
16
Installation requirements
To ensure safe use of the heater, check that the following criteria
are met:
•
Electrical wiring should be installed in accordance with NEC
and all state and local codes.
•
Fuse size (A) and power cable size (AWG) must be suitable
for the heater (see The section called Connection/wiring
diagram, Page 8.
•
The sauna ventilation must comply with the instructions in
this manual (see The section called Positioning the inlet vent,
Page 5, The section called Positioning the outlet vent, Page
5).
•
The position of the sauna heater, control panel, and sensors
must comply with the instructions in this manual.
•
The heater output (kW) must be suitable for the sauna
volume (cu.ft.) (See Table 1, Page 3). The minimum and
maximum volumes must not be exceeded.
•
NOTE: A GFCI device is not required by ETL. A GFCI may
be installed if required by local codes. However, GFCI devic-
es will tend to nuisance trip during use of the product.
Table 1: Voltage and sauna volume
Model
Voltage Sauna volume
Sense U 7 Elite/Pure
208 V
(SPU7)
240 V
Sense U 8 Elite/Pure
208 V
(SPU8)
240 V
Installation tools
The following tools and materials are needed for installation and
connection:
•
level
•
tape measure
•
electric drill
•
screw drivers
Installation planning
Before starting to install your sauna heater:
•
Plan the sauna heater positioning (see the Heater positioning
- normal installation section, page 4).
•
Plan the control panel positioning (see the attached instruc-
tions for the control panel for allowable positioning).
•
Plan the sensor positioning (see Figure 3, page 4).
•
Position the air intake vent (see the Air intake vent positioning
section, page 5).
•
Position the air exhaust vent (see the Air exhaust vent posi-
tioning section, page 5).
•
Plan the electrical installation (see the Connection/wiring
diagram section, page 8).
3
Sauna volume
min. cu.ft.
max. cu.ft.
175
265
175
320
250
360
250
440
Publicité
Chapitres
Table des Matières
Dépannage
