Main Screen; Operation Mode - Saci pumps [e]Winner Manuel D'installation Et D'entretien

6 MAIN SCREEN

This screen will show the status of the pump:
S A C I
1 5 : 2 3
You can view the revolutions and the power consumption of the motor directly, as well as the working point
of the pump, flow and pressure.
From this display if you press the up or down buttons, you will see the water filtered during the day, the
total water pumped since the last reset, the energy consumed in kWh and the hours the pump has worked.

7 OPERATION MODE

The pump, like all pumps designed for swimming pool cleaning, has the main objective of keeping the water
clean and in optimum condition.
The most notable development is that with the logic of the frequency converter and the high performance
motor, this process is achieved with high energy savings.
a) Basic operation:
You can access the three basic functions for operating the pool pump, filtering mode, filter cleaning and
automatic swimming pool cleaning through suction.
The normal operating mode of the frequency converter is the filter function, once the volume of the
swimming pool and the time intervals for activating the filtering have been indicated, the pump will filter
the flow calculated during the time stipulated for that purpose.
It is here where we must take into account that the longer the time the greater the energy savings.
Similarly, the frequency converter will monitor the pressure of the installation, which will be the indicator
of changes in it. As the filter becomes soiled, the pressure rises, and when it reaches the cleaning pressure
it will show a warning to press the filter cleaning (back wash) button and move the valves for this purpose.
The other basic function for a swimming pool pump is for using automatic pool cleaners; this function is
also directly accessible with the vacuum button.
b) Extra functions:
The power of the frequency converter controller provides access to other functions that complement the
swimming pool as a whole, some of them directly from the keys P1 and P2, others by means of internal
parameters and others by external signals connected to the frequency converter.
These functions can be timed, or according to a schedule or an external mechanical command.
There are also parameters that directly manage the use of lights, chlorinators or heaters, reserving the relay
outputs and digital intakes for such uses.
The programming of these functions is in the section on the parameter menus further on.
P U M P S
8 9 3 r p m
5 . 0 m 3 / h
< e > w i n n e r
8 7 W
0 . 1 B a r
M E N U
[e] Winner
25