Blatchford KX06 Instructions D'utilisation page 7

7 Alignment and Setup
Users be aware of potential finger trap hazard.
Note:
Refer to fitting
instructions supplied with
the hydraulic cylinder for
adjustment of
Stance/Swing settings.
Proximal attachment
When fitting a proximal
alignment component
using the 4-bolt option,
ensure the securing
screws protrude by a
maximum of 6 mm and
a minimum of 5 mm to
ensure correct thread
engagement into the
chassis. Two short
screws are supplied with
the device if required
for the two posterior
holes in the chassis; for
example when using the
4-bolt pyramid adaptors
P189310, 189310-C or
189310-R.
Discard screws if not required
Build Line
Swing only,
load line
0 to 10 mm
anterior
ref: 10 mm
(refer to fitting instructions
supplied with the foot)
7
Swing & Stance,
load line 0 to 5 mm
posterior
Trochanter
ref: Swing only
ref: Swing & Stance
22 mm ref. Attachment
Note:
If using an existing socket,
that does not take this
22 mm dimension into ac-
count, an A-P slide adaptor
may be necessary to achieve
the desired TKA line.
Distal pyramid
attachment
Note:
The dome is loose until
the pyramid screws
are tightened. Ensure
anti-rotation 'peg'* is
engaged in the slot
upon tightening.
938271/7-0819
*