Hint For Improved Use; Switching The Under-Bench Air Conditioner On And Off; Selecting The Air Conditioning Mode - Dometic FRESHWELL FW3000 Notice D'utilisation

Operating the under-bench air conditioner
8.3

Hint for improved use

The following hints will optimise the performance of your under-bench air
conditioner:
Improve the heat insulation of your vehicle by sealing gaps and hanging reflective
blinds or curtains on your windows.
If the vehicle has been subjected to direct sunlight for a long time: Operate the
under-bench air conditioner in the "Circulating air" (
open for a while before switching on the "Cooling" (
Avoid opening doors and windows as far as possible in the "Cooling" (
mode.
Select an appropriate temperature and blower speed.
Align the air nozzles sensibly.
Make sure the air nozzles and intake grille are not covered by cloths, paper or
other objects.
Clean the air filter periodically.
8.4

Switching the under-bench air conditioner on and off

I
NOTE
When it is switched on, it begins to condition the air to the values that
were set most recently.
You can use the remote control to switch the under-bench air
conditioner to and from stand-by mode. Press the
You can operate the under-bench by remote control and via LIN bus.
If you use LIN bus control the receiver is not required.
Don't use the under-bench air conditioner if the vehicle is tilted more
than 10°.
When you switch on the under-bench air conditioner, the device waits a few minutes
before operating the compressor.
8.5

Selecting the air conditioning mode

I
NOTE
The under-bench air conditioner must be switched on.
➤ Select the air conditioning mode of your choice using the MODE key, see
chapter "Air conditioning modes" on page 14.
18
FreshWell3000
) mode with the windows
) air conditioning mode.
button.
)
EN