Base Station; Checklist For Missing Data Transfer Of The Outdoor Sensors - ADE WS 1823 Mode D'emploi

Base station

1. Push in a bit the closing flap towards battery
compartment cover and remove the cover of the
battery compartment.
2. Insert 2 batteries of the type LR6 (AA) / 1.5 V as
depicted on the bottom of the battery compartment.
Pay attention to the correct polarity (+/-).
3. Put the battery compartment cover back in place.
As soon as the base station is powered, a beep will sound.
Shortly thereafter, the display will show the following
values:
‚ Indoor temperature and humidity (IN). These values
are measured by the base station.
‚ Indoor temperature and humidity (CH1-3). These
values are measured by individual sensors and
transmitted by radio.
‚ The data from the base station and wireless outdoor
sensors are updated once per minute.
Checklist for missing data transfer of the
outdoor sensors
If no measured values from the outdoor sensors are
displayed, check the following:
‚ Are the batteries inserted correctly?
‚ Does every outdoor sensor actually have its own
channel number?
‚ Is the location of the outdoor sensors suitable (see
"Choosing a location")?
36
Thermometer/Hygrometer WS 1823