Start-Up; Wireless Outdoor Sensors - ADE WS 1823 Mode D'emploi

Start-up

‚ Proceed in the order listed and first insert the
batteries into the wireless outdoor sensors.
‚ Do not use rechargeable batteries, since
their voltage is too low (only 1.2 V instead of
1.5 V). This affects, among other things, the
precision of the measurements.
‚ Where possible, use alkaline rather than zinc-
carbon batteries.
Alkaline batteries last longer, especially at
low outdoor temperatures.

Wireless outdoor sensors

‚ To start up, place the base station and
outdoor sensors close together.
‚ The outdoor sensors can be situated in
different spaces or outdoors.
1. Remove the battery compartment cover from the back
of each outdoor sensor.
2. Insert 2 batteries of type LR03 (AAA)/1.5 V as depicted
on the bottom of the battery compartment. Pay
attention to the correct polarity of the batteries (+/-).
3. Use the channel change switch 1 2 3 for each outdoor
sensor to set a separate channel for each outdoor
sensor (first sensor channel 1, second sensor channel 2,
third sensor channel 3).
4. Slide the battery compartment cover open again.
Thermometer/Hygrometer WS 1823
35