Activate/Deactivate Limit Alarm Pause Function; Read Maximum/Minimum Measurements - VOLTCRAFT DL-260A Notice D'emploi

e) Activate/deactivate limit alarm pause function
• In order to activate/deactivate the limit alarm pause function during recording, the limit alarm must be enabled dur-
ing configuration (please refer to ""MEASUREMENT" options - "ALARM SETTING"" on page 42).
DL-260A: Current (mA)
long press
ENTER
→
pause on
long press
ENTER
→
pause off
• Activate/deactivate limit pause function by holding and pressing button ENTER (7) for few seconds.
• Once the alarm pause function is activated/deactivated, the latest measurement is shown in the display.
Recorded values during activated pause function are shown in the report's graph as usual. However, it is
clearly indicated in the graph when and for how long the pause function was activated.
When the limit pause function is activated during recording, there will be not any alarm indicator "√" or "X".
LED-alarm status, maximum vand Minimum values will not be updated.
f) Read maximum/minimum measurements
DL-260A:
Current (mA)
DL-250V:
Voltage (V)
• Press button DOWN (5) in the function menu several times until you reach the record from which you wish to read
the maximum and minimum readings, e.g. current "mA" (DL-260A) or voltage "V" (DL-250V),
• Press button ENTER (7) to enter maximum and minimum reading mode.
• Press button ENTER (7) to switch between maximum and minimum reading in that selected record.
• Press button DOWN (5) to leave the maximum and minimum reading mode.
"MAX" indicates maximum and "MIN" indicates minimum value.
Maximum and minimum measurements are recorded from the moment recording starts.
For latest readings, the data logger will sense and update the value on display, unless the limit pause func-
tion has been activated. Maximum and minimum readings will stop updating once the device stops logging.
50
mA
mA
Short
mA
press
ENTER
→
Short
V
press
ENTER
→
DL-250V: Voltage (V)
long press
ENTER
→
pause on
long press
ENTER
→
pause off
Short
mA
press
ENTER
↔
Short
V
press
ENTER
↔
V
V
mA
V