Lc Display Indication - VOLTCRAFT DL-260A Notice D'emploi

Mode 13
Function Logs data immediately and circularly.
Should you wish an additional stop mode you choose:
Logging stops after PDF report generation.
Setting Select "CIRCULAR LOGGING" as "RECORD START CONDITION".
Select "AFTER PDF CREATED" as "STOP STYLE".
• For mode 1 to 13, you can apply an additional function to delay the logging start time. Enter minute(s) value in
"START DELAY MINUTES" during configuration setting.
b) LC display indication
• Some settings do not have any indication on LC display. In order to review settings, please refer to "g) Review
configuration settings" on page 44.
• If there is not any display indicator or once the data logger starts/stops recording, the latest measurement is shown
on display.
DL-260A: Current (mA) DL-250V: Voltage (V)
mA
Mode Start mode
1 no display indicator
2 no display indicator
3
no display indicator
4
5
V
Stop mode Remarks
not applicable When memory is full, red LED control light (2) is flashing.
Stop recording by holding button ENTER (7) pressed for
few seconds.
no display
indicator
When memory is full, red LED control light (2) is flashing.
Start recording by holding button ENTER (7) pressed for
not applicable
few seconds.
Start and stop recording by holding button ENTER (7)
pressed for few seconds.
47