Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION MANUAL
CA-ETHR-A
TCP/IP Module
3) The Connect To dialog box appears.
From the Connect using list, select the COM port that the TCP/IP module is connected
to and click OK.
4) The COM Properties dialog box appears.
From the Bits per second list, select 19200. From the Data bits list, select 8. From the
Parity list, select None. From the Stop bits list, select 1. From the Flow control list,
select None. Click OK. All settings in the COM Properties dialog box must match the
TCP/IP module's settings. If you modify the module's settings after performing these
steps, make sure to edit HyperTerminal's COM port settings.
cdvi.com
7
cdvigroup.com
Publicité
Chapitres
Table des Matières
