Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION MANUAL
CA-ETHR-A
TCP/IP Module
3)
The module's current values will appear one at a time. Type a new value and press
[
] on your computer's keyboard. If you want to keep the current value, press
ENTER
[
] without typing a value. Repeat these steps until all settings are programmed.
ENTER
When fi nished, press the [
By default the serial port is 2. If you need to use the 5-pin serial connector (port 1)
to connect the TCP/IP to the serial device (refer to "Hardware Connections" on page
15), do not change the value of the serial port now. You will be able to select port
1 later, after accessing the module's Web page. This allows you to make sure that
the module was confi gured properly and that you can access it through the Web.
4) Any modifi ed settings must be saved.
From the Confi guration Menu, press 3 on your computer's keyboard.
5) Press 1 on your computer's keyboard to save.
cdvi.com
10
cdvigroup.com
] bar to exit this menu.
SPACE
Publicité
Chapitres
Table des Matières
