INSTALLATION MANUAL
CA-ETHR-A
TCP/IP Module
Step A - Hardware Connections
To confi gure the TCP/IP module via its serial port, you must connect the module to a
computer's COM port. Refer to Figure page 6 and to the instructions that follow:
1) Apply 12Vdc to the terminals labeled 12V and GND on the TCP/IP module. Power can
be supplied from the auxiliary output of the serial device (i.e. controller) or from a
separate power supply.
2) Connect the DB-9 to modular phone jack cable between the modular phone jack
on the TCP/IP module and an available COM port on your computer.
Step B - Set up HyperTerminal
The fi rst time you connect using this method you must set up HyperTerminal. If you have
already set up HyperTerminal, go to "Start Communication" on page 8.
1) Click Start, point to Programs, point to Accessories, point to Communications and then
click HyperTerminal.
2) The Connection Description dialog box appears.
In the Name text box, type a descriptive name such as Confi guring TCP_IP Module.
Select the desired icon and click OK.
cdvi.com
6
cdvigroup.com
Figure 3: Serial Communication