Problems; Configuring The Module; Confi Guring Via Serial Port - CDVI CA-ETHR-A Manuel D'installation

INSTALLATION MANUAL
CA-ETHR-A
TCP/IP Module
Do not apply power to both the Serial connector and the 12Vdc Power input
at the same time.
The PGM output and Zone input are reserved for future use.

Problems?

If you experience any problems during the installation or use of this module, contact us on
our website at www.cdvigroup.com.

2] CONFIGURING THE MODULE

Before using the TCP/IP module, you must confi gure it to communicate on a LAN. The
module can be confi gured by one of two methods:
- Using a commercial serial communication program, such as HyperTerminal, to access
the module's serial port (refer to "Confi guring Via Serial Port" below).
- Using a standard Web browser to access the module's internal Web pages
(refer to "Confi guring Via Web" on page 11).
To confi gure the module through its internal Web pages, you must fi rst set the module's
Local IP Address through its serial port.
Confi guring Via Serial Port
To confi gure the module using a commercial serial communication program, such as
HyperTerminal, follow the steps detailed below. The fi rst time you confi gure the module,
you must use this method. To confi gure the module using its internal Web pages,
refer to "Settings and Menus" on page 18.
Although these steps refer to HyperTerminal, you can use any serial communication
program that supports the same parameters.
Step A - "Hardware Connections" (page 6)
Step B - "Set up HyperTerminal" (page 6)
Step C - "Start Communication" (page 7)
Step D - "Confi gure the Module" (page 8)
cdvi.com
5
cdvigroup.com