CDVI CA-ETHR-A Manuel D'installation page 12

INSTALLATION MANUAL
CA-ETHR-A
TCP/IP Module
1) Apply 12Vdc to the terminals labeled 12V and GND on the TCP/IP module. Power can
be supplied from the auxiliary output of the serial device (i.e. controller) or from a
separate power supply.
2) Connect a twisted pair Ethernet wire (10BaseT) between the TCP/IP module's RJ-45
network connector and the LAN.
Step C - Access the Module's Web Page
Once a Local IP Address is assigned to the TCP/IP module and the module is connected
to the LAN, you must establish communication between the module and a computer
on the LAN.
1) From a computer connected to the LAN, open Internet Explorer.
2) In the Address bar, type the TCP/IP module's Local IP Address and press [
computer's keyboard. A Login window appears. Do not type any of the zeros at the
start of each set of 3 digits. For example, if the Local IP Address is 010.010.020.003,
you would type 10.10.20.3.
cdvi.com
12
cdvigroup.com
Figure 4: Web Connections
] on your
ENTER