SEVERIN KS9878 Mode D'emploi page 9

GB
Translation from original operating manual
Refrigerator for bottles
Dear Customer,
Before using the appliance, please read the following
instructions carefully and keep this manual for future reference.
The appliance must only be used by persons familiar with these
instructions.
Connection to the mains supply
∙ The appliance should only be connected to an earthed
socket installed in accordance with the regulations. Make
sure that the supply voltage corresponds with the voltage
marked on the rating label.
∙ This product complies with all binding CE labelling directives
(see EC-Declaration of Conformity at the and of the
manual).
∙ Do not operate this unit by means of a transformer or,
together with other electrical appliances, by means of an
extension cable.
∙ To prevent noise vibration, ensure that the power cord does
not touch any part of the rear of the unit (e.g. the heat-
exchanger).
Designated use
∙ This appliance is a compressor refrigerator designed for
cooling and storing bottled beverages only.
∙ Refrigeration appliances are classifi ed into certain climate
classes. Please refer to the product data sheet for
information on the classifi cation for this unit.
∙ This appliance is intended for commercial use.
∙ No responsibility is accepted if damage results from
improper use, or if these instructions are not complied with.
Important safety instructions
∙ Before it is connected to the mains power, the unit
must be thoroughly checked for transport damage,
including its power cord. In the event of any such
damage being found, the appliance must not be
connected to the mains.
∙ In order to comply with safety regulations and to
avoid hazards, any repairs or modifi cations to this
unit must be carried out by our authorised service
personnel, including the replacement of the power
cord.
∙ Remove the plug from the wall socket
- in case of any malfunction,
- during cleaning,
- before maintenance or repair work is carried
out.
∙ To avoid the risk of electric shock, do not clean the
appliance with water and do not immerse it in water.
∙ The power cord should be regularly examined for any
signs of damage. In the event of such damage being
found, the appliance must no longer be used.
∙ The maximum load per storage rack is 50 kg.
∙ The cooling circuit in this
appliance contains the
refrigerant isobutane (R600a),
a natural gas with a high level
of environmental compatibility,
which is nevertheless fl ammable. Ensure, therefore,
that none of the components of the refrigerant
circuit become damaged during transportation and
installation of the appliance. If damage to the cooling
circuit does occur, do not switch on or connect the
appliance to the mains power. If there should be
an open fi re or any other sources of ignition in the
vicinity of the refrigerant gas, make sure it is removed
immediately from the area and that the room is then
thoroughly ventilated.
∙ To prevent the risk of personal injury or damage to the
cabinet, the unit must only be transported while in its original
packaging. For unpacking and installation, 2 persons are
needed.
∙ Warning: Do not damage the cooling circuit. Any escaping
refrigerant causes damage to the eyes; there is also a
danger of the gas igniting.
∙ Warning: Keep the ventilation openings in the appliance
enclosure clear of obstruction. Suffi cient ventilation must be
ensured at all times.
∙ Warning: Do not use any external device (e.g. heaters
or heating fans) to accelerate de-frosting; follow only the
methods recommended in this manual.
∙ Warning: Do not operate any other electrical appliances
(e.g. ice makers) inside the cabinet.
∙ Caution: do not remove the cover of the interior LED
light. If there should be any malfunction, please contact the
customer service for assistance.
∙ To avoid the risk of fi re, do not place any thermo-electric
appliances on top of the unit. Do not place liquid containers
on top of the unit, to prevent any leaking or escaping liquid
damaging the electrical insulation.
∙ Do not lean or put undue weight on the shelves, door etc.
∙ Protect the inside of the cabinet at all times from open
fl ames and any other sources of ignition.
∙ When removing the plug from the wall socket, never pull on the
power cord; always grip the plug itself.
∙ We reserve the right to introduce technical modifi cations.
9