SEVERIN KS9878 Mode D'emploi page 10

∙ If the unit is not used for an extended period of time, we
recommend keeping the door open.
∙ If the unit is sold, handed over to a third party or disposed of
at a suitable recycling facility, attention must be drawn to the
presence of the insulation agent 'cyclopenthane' as well as
to the refrigerant R600a.
Familiarisation
1. On/Off switch for interior light
2. Temperature control
3. Temperature indicator
4. Mains indicator light
5. LED interior lighting
6. Fan
7. Storage racks
8. Drain channel cleaning tool
Before using for the fi rst time
∙ Remove any exterior and interior packaging materials.
∙ Please ensure proper disposal of all packaging materials.
∙ Fit the two spacer elements (1),
provided, into the corresponding
guide slots (2) on the rear.
∙ Remove the red transport
securing device (A); this is for
transport purposes only and can
be disposed of.
∙ Fit the covering panel
(provided) below the door.
10
∙ Clean the unit according to the instructions given in the De-
frosting and cleaning section below.
∙ For positioning, we recommend that you tilt the unit slightly
backwards. In this way, the transport rollers can be used to
move it to its intended place of installation.
∙ The unit should only be transported in its vertical position;
do not tilt any more than 30°.
∙ Once the unit has been positioned, wait for about 30
minutes before it is connected to the mains.
∙ If the unit has been tilted more than 30° during transport,
allow it to stand upright for at least 4 hours before it is
connected to the mains.
∙ When the unit is fi rst switched on, a slight 'new' smell may
be noticed. However, this will disappear once the cooling
process has begun.
Installation
∙ The appliance should be set up in a well-ventilated, dry room.
∙ It should be operated in conditions where the relative humidity
is no more than 60 %.
∙ The product data sheet contains details of the ambient
temperature range suitable for this appliance.
∙ Do not use the appliance outdoors.
∙ Ensure that the plug is accessible and can be removed from the
wall socket at any time.
∙ Do not expose the appliance to direct sunlight, and do not
position it next to any heat sources (radiators, cookers etc). If
this cannot be avoided, however, suitable insulation must be in
installed between the heat source and the unit.
∙ The unit must not be installed inside a cabinet, nor directly
below a hanging cupboard, shelf or similar object.
∙ If the unit is installed next to a wall, a minimum lateral distance
of 10 mm is necessary for the door to fully open.
∙ If the fl oor is uneven, the adjustable feet on the unit can be
used to compensate and ensure optimum stability.
Set-up dimensions