SEVERIN KS9878 Mode D'emploi page 11

Ventilation
The heated air around the rear of the unit must be able to
circulate freely. Therefore, ensure that the air circulation is not
obstructed.
Warning: Take special care that the ventilation openings
in the upper part of the rear panel are not blocked or
obstructed.
Temperature control
∙ The unit is activated by connecting it to the mains. It is only
switched off completely when the plug is removed from the
wall socket.
∙ The green mains indicator light shows that the unit is
connected to the mains.
∙ The temperature in the refrigerator cabinet can be adjusted
by setting the temperature control (1-5). Turning the control
clockwise will decrease the temperature, while turning it anti-
clockwise will increase it.
∙ The temperature can be set within a 0 to 10°C range.
∙ The temperature in the cabinet largely depends on factors
such as the ambient temperature, the setting and the
number of bottles stored.
∙ We recommend using a thermometer to check the actual
temperature inside the cabinet and make adjustments as
necessary.
∙ Always ensure that the door is properly closed and that the
seal is not obstructed by bottles stored inside the cabinet.
∙ Following a power interruption, or if the unit has been
switched off on purpose, it may take 3 to 5 minutes before it
switches on again.
∙ Note: With the temperature control in position '0', only
the compressoris switched off, while the fan is still
running.
Interior lighting
∙ The interior light can be switched on by means of the
separate On/Off switch.
∙ Caution: do not remove the cover of the interior LED
light. If there should be any malfunction, please contact the
customer service for assistance.
Reversible door
The design provides for the door to be reversed, i.e. for right-
hinged (default installation) to become left-hinged.
Warning: Always disconnect the unit from the mains before
any maintenance or repair work is carried out.
Before you get started, please note the following:
∙ Always ensure that the correct number of washers are used
on the hinge bolts.
∙ To ensure that the door can close tightly against the frame,
take the utmost care that it is properly aligned during re-
assembly.
1. Lower the unit carefully onto its back.
2. Remove the panel (10) by pulling it outwards.
3. Remove the two screws (7) and take off the bottom hinge
bracket (8), together with the set of washers (6) on the
hinge pin, and the spacer element (5).
4. Remove the two screws from the angled bracket (11) and
take it off.
5. Slide the door (4) off the top hinge pin and take it off.
6. Remove the hinge pin (2) together with the nut (1) and
washers (3) from the top hinge bracket, and fi t the entire
assembly to the opposite side of the cabinet.
7. Turn the door through 180°, and then slide it over the
re-positioned top hinge pin (2).
8. Fit the hinge pin of the bottom hinge bracket (8) into the
door.
9. Replace the bottom hinge bracket (8) together with the
set of washers and the spacer element (5) to the cabinet,
using the screws (7).
10. Screw the angled bracket (11) to the opposite side of the
unit.
11. Re-attach the panel (10).
12. Return the whole unit to its upright position.
11