LGB RHB Krokodil GE 6/6 I 413 Instructions De Service page 9

Note:
We recommend to have the decoder
mounted by the LGB factory service
station. For further information, please
contact your authorized LGB retailer or
LGB Service (see Authorized Service).
Notes for do-it-yourself assembly:
- Pull off the bridge from the decoder
interface.
- Plug the decoder onto the pins of the
PCB. The plug of the decoder cable
only fi ts the PCB pins when aligned
correctly.
- When a decoder is integrated in the
locomotive, the power control switch
(mode switch) is obsolete.
Notes for disassembly:
- If you wish to remove the decoder, the
bridge must be remounted onto the
DCC interface.
- Otherwise, the loco does not work.
Electronic sound
To equip this model with sound features,
we recommend the following products:
- LGB 65004
locomotive sound-module
- LGB 65011 Standing Sound Power
Supply Unit (not required, when
operating an MTS Multi-Train System)
Tip:
If the loco doesn't provide enough space,
of if you do not wish to disassemble it,
the module may also be placed in a
coach. It can be connected to the loco
using the multi-purpose socket.
SERVICE
Do-it-yourself service levels
- Beginner
- Intermediate
- Advanced
12
20405 Inhalt.indd 8 20405 Inhalt.indd 8
Attention!
your warranty.
Note:
For quality service, contact your
authorized retailer or an LGB factory
service station (see Authorized Service).
Lubrication
- The axle bearings and the side
rod bearings should be lubricated
occasionally with a small amount of
LGB Mantenance Oil
Cleaning
- This model can be cleaned externally
using a mild detergent and gentle
stream of water.
Attention!
the detergent.
Replacing the light bulbs
- Upper lantern
- pull lantern housing upwards.
- Using tweezers, remove the bulb.
- Plug in new bulb.
European electric - Reassemble lantern.
- Lower lanterns
- Remove two screws from the
undercarriage.
- Using tweezers, remove the bulb.
- Plug in new bulb.
- Reassemble lantern.
Interior lighting
- Remove 6 screws from the roof.
Note: The screws in the center of the
roof are underneath the roof walkways;
use a straight-blade screwdriver to fi rst
pry out the screws.
- Using tweezers, remove the bulb.
- Plug in new bulb.
Attention!
cables when reinstalling the roof!
Improper service will void
1
.
Do not immerse this model in
:
Do not pinch the electrical
20.03.2008 15:29:58 Uhr 20.03.2008 15:29:58 Uhr