IKRA GM ATHS 4043 Mode D'emploi page 23

c) Avoid unintentional operation. Make sure
that the power tool is switched off before
you connect it to the mains supply and/or
the battery and whenever you pick up or
carry the tool. When carrying the tool with
your finger on the on/off switch or connecting
the tool to the mains supply with the switch
in 'ON' position, this may result in accidents.
d) Remove adjustment tools or wrenches
and the like before you switch the power
tool on. A wrench or other tool that is inside
or on a rotating part of the tool may cause
injury.
e) Avoid unusual postures. Make sure to
have a safe footing and keep your balance
at all times. This will allow you to better con-
trol the power tool in unexpected situations.
f) Wear suitable clothes. Do not wear wide
clothing or jewellery. Keep your hair,
clothes and gloves clear of all moving
parts. Loose clothing, jewellery or long hair
may get caught in moving parts.
g) If dust extraction/collection devices are
provided make sure that they are connect-
ed and used properly. The use of a dust
extraction device may reduce risks caused
by dust.
4) Use and handling of the power tool
a) Do not overtax the power tool. Use the
power tool intended for your type of work
in each case. The use of the suitable power
tool within the stated range of performance
makes working more effective and safer.
b) Do not use a power tool with a damaged
switch. A power tool that cannot be switched
on or off any more is dangerous and must be
repaired.
c) Pull the mains plug and/or remove the
battery before adjusting a tool, changing
accessories or putting the tool aside. This
precaution avoids the unintentional start of
the tool.
d) Store power tools that are currently not
used out of the reach of children. Do not
allow persons to use the tool if they are
not familiar with the tool or these instruc-
tions. Power tools are dangerous if used by
inexperienced persons.
e) Thoroughly maintain your power tool.
Check whether moving parts are working
properly and are not jamming/sticking,
GB | Operating Instructions
f) Keep cutting tools sharp and clean. Thor-
g) Use power tools, accessories, add-on
5) Battery tool use and care
a) Make sure that the device has been
b) Only use charging devices recommend-
c) Only use batteries designed for your
d) Keep unused batteries clear of paper
e) Improper use may result in fluid leaking
6) Service
a) Have the power tool serviced by qualified
5
and whether parts are broken or other-
wise damaged in a way that may affect the
function of the power tool. Have damaged
parts repaired before using the tool. Many
accidents are the result of poorly maintained
power tools.
oughly maintained cutting tools with sharp
cutting edges are jamming less often and are
easier to guide.
tools, etc. in accordance with these in-
structions and in the way prescribed for
the respective type of tool. You should
also consider the working conditions and
the work to be carried out. The use of
power tools for purposes other than those
intended for the respective tool may result in
dangerous situations.
switched off before inserting the bat-
tery. Inserting a battery into a switched-on
power tool may lead to accidents!
ed by the manufacturer to charge the
batteries. Charging units are usually de-
signed for certain types of batteries; if used
with other types there is a risk of fire!
power tool. The use of other batteries may
lead to injury and risk of fire!
clips, coins, keys, nails, screws or other
small metal objects
the contacts. A short circuit between the
battery contacts may lead to burns or fire!
out of the battery. Avoid any contact
with battery fluid. Flush with water in
case of contact. If battery fluid should
get into your eyes seek medical advice
additionally. Leaking battery fluid may lead
to irritations of the skin or burns!
technical personnel only; repairs should
be carried out using exclusively original
spare parts. This will ensure the continued
safe operation of the power tool.
that may bridge