Replacing The Lamp; Closing The Door - Electrolux EN2400AOW Manuel D'utilisation

70 www.electrolux.com
Problem
The temperature in the
appliance is too high.
The temperature in the
refrigeration is too high.
The temperature in
the freezer is too high.
The appliance does
not operate.
The lamp does not work.
If your appliance is still not working properly after making the above checks, contact the
After Sales Centre.

8.1 Replacing the lamp

This appliance is equipped with
a longlife LED interior light.
Only service is allowed to replace the
control unit. Contact your Service Center.

8.2 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
02 12 2013_Electrolux -Rex UM_1.indb 70
Possible cause
The Temperature regulator
may be set incorrectly.
The door is not
closed correctly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
The appliance is switched off.
The mains plug is not
connected to the mains
socket correctly.
The appliance has no
power. There is no voltage
in the mains socket.
The lamp is in stand-by.
The lamp is defective.
Solution
Set a lower temperature.
Refer to "Closing the door".
Let the product tem-
perature decrease to room
temperature before storage.
Store less products
at the same time.
Make sure that there is
cold air circulation in the
appliance.
Store products so that
there is cold air circulation.
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different
electrical appliance to
the mains socket. Contact
a qualiied electrician.
Close and open the door.
Refer to "Replacing
the lamp".
2015-09-22 15:39:55