Preliminary Operations - Beta 1877 Mode D'emploi

INSTRUCTIONS FOR USE
ASSEMBLY
c pp
n t an H nto t
n t a t I nto t
c o C c ck t at t

PRELIMINARY OPERATIONS

o ca ng o t an g a t
pa t ct to a a
n ga g L to c ck t at t
Ot pt t
C o c a g a
GRAVITY DRAINING
ac t c n
to t o tank o t t
o a t t g t o t
CAUTION! The ring nut on the central inlet accommodates a special ventilation system which allows the air pushed
by the gravity drained oil to pass through and be given off, thus preventing the formation of bubbles with splashes.
To avoid plugging this vent, make sure that the bowl is not pulled to stroke end upwards), and that a distance of
at least half a centimetre is kept from it.
A t c ck ng t at c a g a
N a op n co ct ng o
N a c o to n p ct o
CAUTION! The liquid to be inspected must not e ceed the capacity of bowl C 1 litres).
CAUTION! Do not ll the tank beyond the level indicated by level gauge L installed ne t to the tank.
TANK DISCHARGE
tank tt t t
conn ct ng to co p ng A t o
Sa t a Q ca at at
CAUTION! To pressurize the tank, rst close valve N.
Op n ng c a g a
CAUTION! Check that discharge tube Y is secured to either the tank or the target container, to prevent oil leaks into
the environment.
6
n on ca ton o a
at t n ock t t t
ng n t c onto t
O- ng a a a
a n ng op at on c ck t at t
an ct
tank acco ng to t p oc
X
t ca t on a ack an a
o op n t g t n ng kno O an
X c o
ct n t tank
o op n ng t an
n ato co p ng A an a t a
co p
a
X a o t tank to
t c o o t
c
c nt a n t o tank S an
onto tt ng J o t
a capac t o t tank
c n t
t t g t an po t on o t
o a t
a t o can a n n t o
a n o nto t tank
Q to c a g t o o t
a a a
c a g
p oc o
t t g t n ng kno O
a t
c n goo con t on an t at non o t
c t o
ct on o
o o t at t a n a a po
I p a o o n a
nt a
c p
EN
o t o to a n
t tank