Operating; Before Use; Charging The Battery - Royal Dirt Devil Akku-Blitz Mode D'emploi

2 Operating

2 Operating

2.1 Before use

Unpack the appliance and all accessory parts
and check that the contents are complete
(Fig. 2).
ATTENTION:
Always transport/send the appliance in its
original packaging so that it does not
become damaged. Keep the packing for this
purpose. Dispose of any packing material
that is no longer required in accordance with
the provisions applicable in your country.
NOTE:
If you should notice damage due to transport,
then contact your dealer immediately.
1. Assemble the sweeper stick by inserting
the insert tube
correspondingly (Fig. 3). The lower insert
tube (Fig. 3/1) is recognizable by the
release button (Fig. 3/2).
2. Insert the sweeper stick (Fig. 4/1) into the
receiving end (Fig. 4/2). It clicks audibly
into place.
NOTE:
If you want to remove the sweeper stick
again, press the release button (Fig. 4/3)
and pull the sweeper stick (Fig. 4/1) up.

2.2 Charging the battery

ATTENTION:
Only use the charger supplied with the
appliance for charging the battery. If this
condition is disregarded, the appliance may
incur damage or the batteries may be
severely damaged.
The battery must be charged before being
able to work with the appliance. To do this:
1. Connect the power unit first to the brush
foot (Fig. 5/1).
2. Then plug the power unit into the socket
(Fig. 5/2). The charging light (Fig. 5/3) is
illuminated red.
3. Now leave the battery to charge for 16
hours.
and the handle
ATTENTION:
Avoid longer charging times. These shorten
the operating life of the battery.
4. After charging, pull the power unit out of
the socket first and then out of the brush
foot.
NOTE:
Only recharge the battery again if it is
completely dead. This will increase its
operating life.
2.3 Sweeping
.
WARNING:
Check the brush sweeper before each use.
A damaged appliance must never be used.
There is a risk of injury.
1. Switch on the brush sweeper using the on/
off switch (Fig. 1/3).
2. To sweep, push the brush sweeper back
and forth like a vacuum cleaner.
2.4 Switching off and storing
1. Switch off the brush sweeper after
sweeping by using the on/off switch
(Fig. 1/3).
2. Place the brush sweeper outside of the
working area and lock the sweeper stick in
a vertical position. This will help avoid
accidents.
ATTENTION:
Never position the appliance directly against
heat sources (e.g. heating, oven). Avoid
direct sunlight. Heat can damage the
appliance.
„
If you want to store the appliance for a
longer period of time, empty the dust
container and clean it.
„
Store the appliance in a cool, dry room.
11