LG LRG3085ST Manuel D'utilisation page 43

42
BEFORE REQUESTING SERVICE
Symptoms and Questions
Oven light does not work
Oven will not self-clean
"Crackling" or "popping" sound
Too much smoking during a self clean cycle.
Oven door will not open after a self-clean
cycle
Oven not clean after a self-clean cycle
"CLOSE DOOR TO CONTINUE BROILING"
or "DOOR OPENED" appears in the display
"DOOR LOCKED" light is on when you want
to cook
Oven control beeps and displays any F
code error.
Oven racks are difficult to slide
Power outage, clock flashes
"Burning" or "oily" odor emitting from the
vent
Possible Cause/Solution
y The light bulb is loose or defective.
y Tighten or replace the bulb.
y The plug on the range is not completely inserted in the electrical outlet.
y Make sure the electrical plug is inserted into a live, properly grounded outlet.
y The oven temperature is too high to set a self-clean operation.
y Allow the range to cool to room temperature and reset the controls.
y Improper oven controls setting.
y See the "SELF CLEAN" section.
y This is the sound of the metal heating and cooling during both the cooking
and cleaning functions.
y This is normal.
y Too much soil.
y Press the CLEAR OFF button. Open the windows to clear the smoke from
the room. Wait until the DOOR LOCKED light goes off. Wipe up the excess
soil and reset the clean cycle.
y The oven temperature is too high.
y Allow the oven to cool below locking temperature.
y This can take up to 1 hr after the cycle is complete.
y Improper oven controls setting.
y See the "SELF CLEAN" section.
y The oven was heavily soiled.
y Clean up heavy spillovers before beginning the self- clean cycle. Heavily
soiled ovens may need to self-clean again or for a longer period of time.
y The broil or self-clean cycle has been selected but the door is not closed.
y Close the oven door.
y The oven door is locked because the temperature inside the oven has not
dropped below the locking temperature.
y Press the CLEAR OFF button. Allow the oven to cool.
y You have "F6".
y Press the CLEAR OFF button. Allow the oven to cool for one hour. Put the
oven back into operation.
y You have "F9".
y Check the main gas shut-off valve or the oven gas shut-off valve(see "Surface
burners light but oven burner does not" column).
y If the function code repeats.
y Disconnect all power to the range for 5 minutes and then reconnect power. If
the function error code repeats, call for service.
y The oven racks were cleaned in a self-clean cycle.
y Apply a small amount of vegetable oil to a paper towel and wipe the edges of
the oven racks with the paper towel. Do not use lubricant sprays.
y Power outage or surge.
y Reset the clock. If the oven was in use, you must reset it by pressing the
CLEAR OFF button, setting the clock and resetting any cooking function.
y After checking the oven's operation, turn the temperature up to 450 °F and
leave the oven on for at least an hour to help remove any oil which might
cause smoke and odors when first using the oven.