Removing the Drawer
WARNING
Disconnect the electrical power to the range at the main
fuse or circuit breaker panel. Failure to do so can result
in severe personal injury, death, or electrical shock.
Most cleaning can be done with the drawer in place;
however, the drawer may be removed if further cleaning is
needed. Use warm water to thoroughly clean.
1. Fully open the drawer.
2. Remove the two screws.
Remove screws
3. Locate the glide lever on each side of the drawer. Push
down on the left glide lever and pull up on the right glide
lever.
Lever
Push down with finger
4. Pull the storage drawer away from the range.
Lever
Pull up with finger
Replacing the Drawer
1. Pull the bearing glides to the front of the chassis glide.
2. Align the glide on each side of the drawer with the glide
slots on the range.
3. Push the drawer into the range until levers "click "
(approximately 2 inch).
4. Pull the drawer open again to seat bearing glides into
position.
5. Replace the two screws.
WARNING
DO NOT touch interior surfaces of oven between door
and drawer.
- During and after use, do not touch interior surfaces of
oven between door and drawer until they have had
sufficient time to cool.
- Failure to follow this warning result in severe personal
injury.
35
CARE AND CLEANING