Optional Rear Filler; Removing The Drawer; Replacing The Drawer - LG LSE3090ST Manuel D'utilisation

38
CARE AND CLEANING

Removing the drawer

WARNING
Disconnect the electrical power to the range at
the main fuse or circuit breaker panel. Failure to
do so can result in severe personal injury, death, or
electrical shock.
Most cleaning can be done with the drawer in place;
however, the drawer may be removed if further cleaning
is needed. Use warm water to thoroughly clean.
1. Fully open the drawer.
2. Remove the two screws.
Remove screws
3. Locate the glide lever on each side of the drawer.
Push down on the left glide lever and pull up on the
right glide lever.
Lever
Push down with finger
4. Pull the drawer away from the range.

Replacing the drawer

1. Pull the bearing glides to the front of the chassis
glide.
2. Align the glide on each side of the drawer with the
glide slots on the range.
3. Push the drawer into the range until levers "click "
(approximately 2 inch).
4. Pull the drawer open again to seat bearing glides
into position.
5. Replace the two screws.
Lever
Pull up with finger

OPTiONAL REAR FiLLER

If the counter does not bridge the opening at the rear
wall the rear filler kit, that is provided with the slide in
range, will be needed.
NOTE
If the countertop depth is greater than 25" there
will be a gap between the filler kit and the back wall.
If the countertop depth is less than 24", the control panel
will not sit flush with the countertop.