Operation Mode - INFOSEC G1 Manuel Utilisateur

Description of Operating Mode

Operation mode

Standby mode / Power saving mode
Note:
*Standby mode: The inverter is not
turned on yet but at this time, the
inverter can charge battery without AC
output.
*Power saving mode: If enabled, the
output of inverter will be off when
connected load is pretty low or not
detected.
Fault mode
Note:
*Fault mode: Errors are caused by errors
inside circuit or external reasons such as
high temperature, output short-circuit
and so on.
Line Mode
Battery Mode
19
INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)240 94 29 51 - hotline@infosec.fr – 08 18 AA 59 203 14
Description
No output is supplied by the unit
but it still can charge batteries.
No output and No charging
The unit will provide output
power from the mains. It will
also charge the battery at line
mode.
The unit will provide output
power from battery
LCD display
Charging by utility.
No charging.
No charging.
Charging by utility.
Power from battery only.