INFOSEC G1 Manuel Utilisateur page 18

Auto restart when overload
10
occurs
Auto restart when
11
temperature is too high
12 Alarm control
Auto return to default
13
display screen
14 Backlight control
Beeps while primary source
15
is interrupted
16 Record Fault code
17 Setting communications ID
Setting communications
18
baud rate
Setting communications
19
stop bit
Setting communications
20
check bit
17
INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)240 94 29 51 - hotline@infosec.fr – 08 18 AA 59 203 14
Saving mode enable
Restart disable
(default)
Restart disable
(default)
Alarm on (default)
Return to default
display screen
(default)
Stay at latest screen
Backlight on (default)
Alarm on (default)
Record enable
Default setting: 001
Setting range is from 000 to 255. Increment of each click is 1.
2400 4800
9600 (default) 19200
01 (default) 02
00 (default) 01
If enabled, the output of inverter will
be off when connected load is pretty
low or not detected.
Restart enable
Restart enable
Alarm off
If selected, no matter how users
switch display screen, it will
automatically return to default display
screen (Input voltage /output
voltage) after no button is pressed for
1 minute.
If selected, the display screen will
stay at the latest screen user finally
switches.
Backlight off
Alarm off
Record disable (default)