Product Description; Technical Data; Installation - 3M ESPE RotoMix Notice D'utilisation

14. Do not expose the device to solvents, flammable liquids,
and strong heat sources as these may damage the
plastic housing.
15. Cleaning the unit, ensure that no cleaning agent enters
the device since this may lead to electric short circuiting
or hazardous malfunctions.
16. Pay attention to capsule leak tightness when mixing.
Capsules that are not leak tight contaminate the
device with mercury. Contaminated devices cannot be
repaired and must be disposed of as contaminated
waste according to local laws.
See the safety data sheet for the amalgam used for first
aid, measures to take in case of unintended release,
handling, storage, exposure limitation, and personal
protective clothing.
Protective cover

2. Product Description

The RotoMix unit is a mixing device for dental filling
materials and cements in capsules. Unlike conventional
capsule mixers, the device uses a rotating motion which
is faster and more efficient and leads to improved
homogeneity of the mixed pastes. In addition, RotoMix
offers the option to centrifuge the capsules after mixing.
Depending on the viscosity this procedure may reduce air
bubbles in the material. Desired mixing and centrifugation
times may be programmed into the mixing programmes
"P1"-"P4". Moreover, two pre-set mixing times, "10s" and
"8s", can be selected.
Operating Instructions should not be discarded for the
duration of product use.
2

3. Technical Data

Drive unit:
Operating mode:
Controller:
Capsule holder:
Capsules:
Housing:
Mixing speed:
Centrifugation speed: typically 2950 for 6 g-capsules
Operating
temperature:
Humidity:
Main voltage:
Power requirements: 390 VA
Power
Fuses:
switch
Capsule
Dimensions:
holder
Revolving Weight:
platform
Continous sound
pressure level:
Control panel Year of manufacture: see rating plate

4. Installation

Prior to the first start-up remove the transport safe guard
(foam ring) and instruction card.
Connect the RotoMix unit to the power supply and switch
on the unit with the power switch on the back of the device.
The display shows the mixing time of programme 1.
The following basic settings are factory-set:
Programme 1 (key "P1"):
Programme 2 (key "P2"):
Programme 3 (key "P3"):
Programme 4 (key "P4"):
Ball-bearing motor with integrated
self-resetting overheat cut-off
Short-term operation, 2 min On/
5 min Pause (to prevent needless
motor heating)
Microprocessor-controlled,
high-precision mixing time control
by quartz timing mechanism
Self-locking
Diameter max.19 mm, total length
max. 58 mm, length without tubes
max. 38 mm, weight max. 6 g
Housing and protective cover consist
of high impact-resistant plastics
typically 2850 for 6 g-capsules
18°C... 40°C/64°F...104°F
max. 80% at 31°C/88°F,
max. 50% at 40°C/104°F
120 V, 230 V, 50/60 Hz, for voltage
setting refer to the rating plate
230 V: 2 A time-lag fuse
120 V: 3.2 A time-lag fuse
(W x H x D) 180 x 210 x 250 mm
4000 g
= 73.8 dB(A)
12 sec mixing,
3 sec centrifugation
9 sec mixing,
3 sec centrifugation
7 sec mixing,
3 sec centrifugation
5 sec mixing,
3 sec centrifugation