Technical Data; Noise Emission Levels; Assembly And Operation; Before Using For The First Time - EINHELL TPR 200/2 Mode D'emploi

Anleitung TPR 200-2 SPK1
Wear safety gloves.
Never use cracked diamond cutting wheels.
Replace immediately.
Caution! The cutting wheel runs on after the
machine is switched off!
Never apply side pressure to the diamond cutting
wheel in order to bring it to a halt.
Caution! The diamond cutting wheel must be
cooled with water at all times.
Always pull out the power plug before changing
the cutting wheel.
Use only suitable diamond cutting wheels.
Never leave the machine unattended in rooms
with children.
Always pull out the power plug before examining
the electric motor compartment system.

5. Technical data

Motor rating
Motor speed
A.c. motor 230 V ~ 50 Hz
Insulation material class
Insulation
Cut length
Jolly length
Cut height 90° max. 30 mm
Cut height 45° max. 25 mm
Cutting table:
Dimensions 570 x 385 mm
Diamond cutting wheel ø 200 x ø 25.4

Noise emission levels

The noise emitted by this saw is measured in
accordance with EN ISO 3744; EN ISO 11201
The noise at the workplace may exceed 85 db
(A). The user will require noise protection
measures if this is the case. (Wear ear-muffs!)
With-load No-Load
operation operation
Sound pressure level 94 dB(A) 76 dB(A)
Sound power level 107 dB(A) 89 dB(A)

6. Before using for the first time

The machine must be set up so that it stands
firmly, i.e. it must be securely screwed to a work
27.06.2005 9:33 Uhr Seite 9
bench, the base frame supplied in delivery, or
similar.
All covers and safety devices must be correctly
attached before the machine is used for the first
time.
The cutting wheel must rotate smoothly.
Check that the voltage on the rating plate is the
same as your supply voltage before you connect
the machine to the power supply.

7. Assembly and operation

7.1 Assembly (Fig. 1-6)
Fasten the feet (18) to the base frame (12) with
the 4 screws (19).
Turn the sub-frame upright.
Insert the two screws (37) for the trough fixture
through the square holes and place the trough
(3) in the base frame (12).
800 W
Fasten the cooling water pump (13) to the mount
3000 rpm
(38). Place the tile cutter into the trough and
screw on the trough fixture (39).
Class B
Unscrew and remove the star handle screw (11)
and spacer (40) and keep them in a safe place.
IP54
Fill the trough with water until the cooling water
520 mm
pump is completely immersed.
520 mm
7.2 ON/OFF switch (Fig. 7)
To switch on, press the "1" on the ON/OFF
switch (16).
Before you begin cutting, wait until the cutting
wheel has reached maximum speed and the
cooling water pump (13) has started supplying
the cutting wheel with water.
To switch off, press the "0" on the switch (16).
7.3 90° Cutting (Fig. 8/9)
Loosen the star grip screw (27).
Set the angle stop (5) to 90° and retighten the
star grip screw (27).
Retighten the screws (28) to fasten the angle
stop (5).
Move the machine head (29) to the far end with
the handle (9).
Position the tile against the rail fence (6) on the
angle stop (5).
Switch on the tile cutting machine.
Caution: Always wait until the cooling water has
reached the cutting wheel (2) first.
Move the machine head (29) slowly and
smoothly forward through the tile with the handle
GB
9