Technical Data; Maintenance And Cleaning - EINHELL DSL 250/2 Mode D'emploi D'origine

Anleitung_DSL_250_2_11060_SPK1:_
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
Repairs and maintenance work are to be carried out
only by authorized specialist workshops.
Please note!
The power of the tool will be reduced if you use a
hose that has too small an inner diameter or
which is too long.

4. Technical data

Permissible working pressure max.:
Idle speed: 22,000 min
Air consumption (6.3 bar): 128.3 l/min
Recommended hose diameter:
Weight:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 792-9.
L sound pressure level 93.8 dB(A)
pA
K uncertainty
pA
L sound power level 83.5 dB(A)
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 792-9.
Vibration emission value a < 2.5 m/s
2
h
K uncertainty = 1.5 m/s 2
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever
01.09.2010 10:02 Uhr
necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
Air quality
cleaned and oiled
Air supply
via conditioning unit with filter pressure reducer
and mist oiler
Compressor capacity
approx. 250 l/min. equivalent to a motor rating of 2.2
kW
Work settings
6 bar working pressure set at the pressure
reducer or filter pressure reducer
Please note:
6.3 bar
When working with the pin grinder, be sure to
wear the necessary protective clothing. Observe
-1
the safety regulations.
Ø 10 mm
5. Putting into operation
0.65 kg
Screw the supplied plug-in nipple into the air
connection after you have wound 2 to 3 layers of
sealing tape around the thread. Insert adapter sleeve
size Ø 3 mm or Ø 6 mm depending on which
grinding pin you want to use. To do so, unscrew the
lock nut, insert the adapter sleeve and re-tighten the
lock nut by hand. Then insert the correct grinding pin
(make sure it has the correct shaft diameter!) and
3 dB
tighten the lock nut with the two chuck keys, using
the one key to hold the adapter sleeve mount.
3 dB

6. Maintenance and cleaning

Observance of the following maintenance
instructions will ensure that this quality tool gives you
years of troublefree service.
Regular lubrication is vital for the long-term, reliable
operation of your pin grinder. Use only special tool oil
for this purpose.
You can choose from the following options for
lubricating the tool:
6.1 By mist oiler
A complete conditioning unit includes a mist oiler and
is fitted to the compressor.
Seite 9
GB
9