Switching On For The First Time - Franke VITAL Manuel D'installation Et Mode D'emploi

SWITCHING ON FOR THE FIRST TIME

Capsule filter
Before using Vital Capsule
for the first time:
9 Check if installation was done
according to the manual.
9 Check that water supply to the
system is turned ON.
9 Check the filter spout to be without
a filter inserted.
Open the water on the filter faucet
X
and let it run without a filter for
4 to 5 minutes. This step is very
important to empty the house water
supply system from construction
contaminations!
Take the filter out of the plastic and
X
enter it in the housing nose (with the
twin system: check if it is the right
filter).
Screw the housing nose on (if you
X
turn it first a halve a turn left before
closing right, it will be easier).
Take the battery protecting flag out
X
to activate the battery.
Activate the electronic with the reset
X
needle by pressing for about 3 or
4 seconds.
Led light will blink: green, green,
X
green indicating that system is ready.
Then light will turn off.
Turn on the faucet to flush the new
X
filter for 30 seconds to remove any
carbon dust and activate the filter
(see page 5/1 ABC).
Filtration is ready.
X
Chiller
When you first use the product, in order
to remove any air inside the system, it is
recommended to:
Open the water valve and wait a few
Z
minutes to make sure there are no
water leakage.
If the system.includes electrical
Z
controls, connect the product to the
power supply to enable the delivery
keys.
Press the cold water button to let the
Z
air out. Release the button only when
the water starts coming out.
Drain a few litres of cold and warm
Z
water.
When you first install the product,
Z
you will have to wait approx. 1h
before dispensing cold water.
– 19 – – 19 –
Timer unit
LED light
Reset timer hole
Reset needle key
EN