Cebora WIN TIG AC-DC 270T Guide Rapide Pour L'installation page 12

EN WIN TIG INSTALLATION AND USE QUICK GUIDE
Translation of the original instructions
1 SYMBOLS ...................................................................................................................................................... 13
2 WARNINGS .................................................................................................................................................... 13
3 INSTALLATION .............................................................................................................................................. 13
3.1 CONDITIONS IN THE SURROUNDING ROOM ............................................................................................. 14
4 MAINS CONNECTION .................................................................................................................................. 14
5 LIFTING AND TRANSPORT ......................................................................................................................... 14
6 DESCRIPTION OF THE DEVICE .................................................................................................................. 15
6.1 FRONT PANEL CONNECTOR DESCRIPTION .............................................................................................. 16
6.2 REAR PANEL CONNECTOR DESCRIPTION ................................................................................................. 17
6.3 DESCRIPTION OF DISPLAY .......................................................................................................................... 18
7 SET-UP ........................................................................................................................................................... 18
8 TECHNICAL SPECIFICATIONS .................................................................................................................... 19
INSTRUCTION MANUAL FOR ARC WELDING MACHINES
IMPORTANT: BEFORE USING THIS DEVICE, READ CAREFULLY THE INSTRUCTIONS IN GENERAL WARNINGS MANUAL 3301151.
Copyright
The copyright of these operating instructions is owned by the manufacturer. The text and illustrations correspond to the technical
specifications of the device at the time of printing and are subject to change. No part of this publication may be reproduced, stored in
a filing system or transmitted to third parties in any form or by any means, without the manufacturer's prior written authorisation. We
are always grateful to be informed of any errors and suggestions for improving the operating instructions.
Always keep this manual at the place where the device is used.
The equipment can only be used for welding or cutting operations. Do not use this device to charge batteries, defrost pipes or start
motors.
Only expert staff can install, operate, maintain and repair this device. An expert staff member means someone who can judge the work
assigned to them and recognise possible risks based on their vocational training, knowledge and experience.
Any use that differs from what is expressly indicated and is implemented in different ways or contrary to what is indicated in this
publication amounts to improper use. The manufacturer declines any liability arising from improper use that may cause accidents to
people and possible system malfunctions.
This exclusion of liability is acknowledged upon commissioning of the system by the user.
The Manufacture is unable to monitor compliance with these instructions or device installation, operation and use, and maintenance
conditions and methods.
Inappropriate execution of the installation may lead to material damage and possible personal injury. Therefore, no liability is assumed
for loss, damage or cost arising out of or in any way connected with improper installation, incorrect operation or inappropriate use
and maintenance.
It is not permitted to connect two or more power sources in parallel.
If you wish to connect several power sources in parallel, ask for written authorisation from CEBORA which will determine and authorise
procedures and conditions for the required application in compliance with current product and safety regulations.
The installation and management of this device/system must comply with the IEC EN 60974-4 standard.
Liability regarding system operation is expressly limited to the system's function. Further liability of any kind is expressly excluded. This exclusion
of liability is acknowledged upon commissioning of the system by the user.
The Manufacture is unable to monitor compliance with these instructions or device installation, operation and use, and maintenance conditions
and methods provided in the 3301151 manual.
Inappropriate execution of the installation may lead to material damage and consequently to personal injury. Therefore, no liability is assumed for
loss, damage or cost arising out of or in any way connected with improper installation, incorrect operation or inappropriate use and maintenance.
This user manual is part of the overall documentation and is invalid unless it is used in conjunction with all other parts of the documentation:
3301151 General warnings
3301062 Machine Instruction manual
12/21
3301229
SUMMARY
3301084
3300948
WinTIG Process Image manual
Cooling unit instruction
3301229