5. General handling of the heating hose
The heating hose is to be handled carefully. Avoid excessive bending or kinking of the hose; the smallest bending radius
is around 20 cm. Do not run over the heating hose and protect it from sharp objects and edges. Risk of injury from a
leaking hose. Replace damaged hoses immediately. Never repair a defective hose! The heating hose cannot be discon-
nected from the heating element / thermostat. Do not open this screw connection. Always unroll heating hoses comple-
tely. When working on scaffolding guide the heating hose along the outside of the scaffolding.
6. Interruption of work
During prolonged breaks from work relieve the pressure on the airless unit and unplug the heating hose plug connector
from the mains. When using quick-drying or two-component coating material it is essential that the unit is flushed with
a suitable cleaning agent within the processing time/open time of the material, otherwise it could result in damage to
the unit or require significant expense for cleaning.
7. Cleaning the unit
Cleanliness is the best guarantee for trouble-free operation. Under no circumstances should any material residues be
allowed to dry and set in the unit. When the spraying process has been completed flush the unit using a suitable sol-
vent in accordance with the manufacturer's instructions.
When cleaning with solvents (except water) always switch off the heating element!
The solvent containers (except for water) must be earthed!
Caution!. Do not pump or spray into containers with a small opening (bung hole)!
Refer to the safety regulations. Warm water facilitates the cleaning process for water-soluble
coating materials. The heating hose can be switched on for this.
Cleaning the unit from outside
First remove the mains plug from the socket. Risk of short circuit as a result of water penetration! Never spray the
unit using a pressure washer or steam cleaner. Wipe the outside of the unit using a cloth soaked in a suitable cleaning
agent.
8. Technical data
Line voltage / fuse:
Controllable heat output:
Temperature control range: 55° C
Temperature setting:
Length of hose:
All information is without guarantee! Subject to technical modifications and errors!
9. Repairing the unit
Defective hoses, heating elements and temperature regulators should only be repaired by authorised STORCH service
centres. Please contact the STORCH service hotline on 0800 / 7867247 for further information.
230 V / 50 Hz / 2,6 A
600 W
automatic, non-controllable
7,5 m
39
Translation of the original instruction