EUROM Wall Designheat 2000 Manuel D'utilisation page 18

The heater has to preferably be positioned at and permanently connected to an
electric socket. This connection may only be made by a qualified electrician and, for
that reason, is not described here.
In this booklet, for reasons of safety, use with a plug should be assumed; when
there is a permanent connection, any passages about the plug do not apply.

Drill two holes in the wall at the required locations, to fit the plugs exactly: make sure
these holes are horizontal and 39.4 cm apart. Insert plugs and screws into the holes.
Allow the screws to stick out by 10 mm. Hook the heater over the screws using the
hanging eyes, then slide to the left and pull downwards. The fixing material supplied is
suitable for brick walls. Consult a specialist, for instance at a DIY store, if your wall is
built of other material.

Check whether the heater is secured to the wall; if necessary
insert the screws a little further into the plugs.

Attach the heater using the materials supplied. Place the
bracket on top of the heater (see picture) with the short side
against the wall. Mark the location of the hole on the wall and
remove the heater. Drill a hole at the marked spot and insert a
plug. Now hang the heater in place and screw the bracket to
the wall, as shown in the diagram. The heater is now installed.
Using for the first time and Operation

Make sure that the main switch is OFF (O)

Unroll the electrical cable entirely and insert the plug into a suitable 220/240V socket.

Set the main switch to ON (l). The display will show the current temperature.
With the remote control

Press the ON/OFF button (7): the fan will begin to rotate and the fan indicator lamp A
will light up.

By pressing the MODE button one or more times, you can set the heater to half of full
power or select just fan. The indicator lamp for the chosen mode will light up.

Pressing button 10 (Oscil) will start the oscillating function: the flap in front of
discharge vent 5 will move and air will start to flow. This function works while heating
and ventilating. By pressing the button again, the oscillating function is turned off.

the required temperature can be set using buttons 12 and 13. The display will
momentarily show the required temperature and before returning to the current
temperature. the built-in thermostat will automatically choose the most suitable power
and turn the the appliance off when the required temperature has been reached. The
appliance will be automatically activated if the temperature drops. To turn off the
thermostat function, press the "Cancel"button (11).

The required switch-off time can be set using the Timer button (9). Keep the Timer
button pressed while the appliance is in operation: the will show the number of hours
operation that you have set, up to a maximum of 8 hours. If you stop pressing the
Timer button, the display will flash the set number of hours and then return to the
current temperature. The appliance will switch itself off when the set number of hours
have expired.

Press the ON/OFF button again in order to switch the heater off. When you have been
using the device to provide heat, it will cool off for 30 seconds before switching off
entirely. During cooling, the indicator lamp A will flash on and off. Once the cooling
period has come to an end and the signal light A has gone off, press the main switch 1
to turn off and remove the plug from the socket.
18