EUROM Wall Designheat 2000 Manuel D'utilisation page 17

any other defect. Return the complete product to the vendor or to a certified electrician
for inspection and/or repair. Always ask for original parts.
27. Do not use attachments and/or accessories, not recommended or supplied by the
manufacturer.
28. The appliance (incl. cord and plug) may only be opened and/or repaired by properly
authorised and qualified persons.
29. Only use this heater for its intended purpose and as described in this instruction
manual.
Not abiding by instructions 27, 28 & 29 may lead to damage, fire and/or personal injuries.
A failure to adhere to these rules also immediately nullifies the guarantee and vendor,
importer and/or manufacturer do not take responsibility for any of the consequences!
Description
The remote control works on a cell battery, type CR2025 (3V)
Location and Connection

Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.

Select a suitable place for the device, taking into account the safety instructions. The
WALL DESIGNHEAT 2000 has to be hung from a wall and therefore may not be used
in a lying, leaning, hanging or standing position! The wall on which the device is hung
has to be firm, flat and perfectly vertical and made from non-inflammable material that
cannot melt. It has to be at least 50 cm away from side walls and the top has to be at
least 180 cm above the floor.
1. Main switch
2. Mode button (MODE)
3. Timer button
4. Suction grilles
5. Air discharge grille
6. Display
Remote control:
7. ON/OFF button
8. Mode switch (MODE)
9. Timer button
10. Oscil=oscillate
11. Cancel=cancel
12. Increase temperature
13. Decrease temperature
Display:
A. Ventilation lamp
B. Heating lamp (half power)
C. Heating lamp (full power)
D. "Oscillation" lamp
E. "Timer set" lamp
17
(rear side)