shelyak SENTINEL PF0007 Guide Utilisateur page 59

Name
Type
Nbre bytes
Comments
Calculated afterward
Saved in EEPROM
Name
Type
Nbre bytes
Comments
Calculated afterward
Saved in EEPROM
Name
Type
Nbre bytes
Comments
Calculated afterward
Saved in EEPROM
Name
Type
Nbre bytes
Comments
Calculated afterward
Saved in EEPROM
Name
Type
Nbre bytes
Comments
Calculated afterward
Saved in EEPROM
Sentinel – User Guide (Français / English) – DC0011C
GainLight
Byte (0-255)
1
Gain for the photodiod light sensor measure. Possible values are 1x, 10x,
and 100x.
No, directly from a 8 bits number from Sentinel
Yes
DividLight
Byte (0-255)
1
Indicate dividing factor for frequency used for the light sensor. Possible
values are 1x, 2x, 10x, and 100xNon
No, directly from a 8 bits number from Sentinel
Yes
ValidLight
Boolean
1
Indique si par rapport à la mesure précédente le gain et le diviseur de la
photodiode ont changés. S'ils ont changés la mesure ne peut pas être
validée.
Yes, from a 8bits number from Sentinel.
Yes
Lumex
Single, real on 32 bits.
4
This if the Log10 of pulse count from light sensor between time (t-1) and
last measure at (t).
Yes, from
LightValueAbs, GainLight & DividLight
ValidLight=TRUE.
Yes, from
LightValueAbs, GainLight, DividLight & ValidLight
PowerVolts
Single, real on 32 bits.
4
In Volts, provide tension value powering the Sentinel
Yes, from a 16bits number from Sentinel.
No
and previous measure; only if
59 / 61