Intended Use; Possible Misuse - Hilti WSR 22-A Mode D'emploi Original

▶ Never cut into unknown materials and keep the line of cut above and below the workpiece free of
obstacles. If the saw blade strikes an object it may cause the power tool to kick back.
▶ Apply moderate pressure and select a suitable stroke rate when using the pipe-cutting adapter
(accessory), especially when cutting large-diameter pipes. This will help to prevent the power tool
overheating.
▶ Warning! When cutting through pipes, e.g. when carrying out demolition or installation work,
check to ensure that the pipes no longer contain liquids and empty them if necessary. When
cutting through pipes, hold the power tool above the level of the pipe you are cutting through.
The power tool incorporates no protective measures to prevent ingress of water or dampness. Liquids
running out of pipes may cause a short circuit in the power tool.
▶ Do not attempt to cut material thicker than the specified max. thickness for which the saw is
designed and do not use unsuitable saw blades (reciprocating saw blades of the wrong size or not
equipped with a 1/2" connection end).
Careful handling and use of batteries
▶ Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
▶ Do not expose batteries to high temperatures and keep them away from fire. There is a risk of
explosion.
▶ Avoid ingress of moisture. Ingress of moisture may cause a short circuit, resulting in burning injuries or
fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over
80°C (176°F). This presents a risk of fire, explosion or injury through contact with caustic substances.
▶ Never continue to use or attempt to charge damaged batteries, e.g. batteries with cracks, broken
parts, bent or pushed-in / pulled-out contacts).
▶ Do not use the battery as a power source for other unspecified power tools or appliances.
▶ If the battery is too hot to hold, it may be defective.In this case, place the power tool in a non-
flammable location, well away from flammable materials, where it can be kept under observation
and allowed to cool down. Contact HiltiService after the battery has cooled down.
3 Description
3.1 Overview of the product
Chuck (blade holder)
@
Control switch
;
Safety lock
=
Grip
%
Battery charge status display
&
Battery release button
(

3.2 Intended use

The product described is a cordless reciprocating saw. It is designed for cutting wood, wood-like materials,
metals and plastics.
The product is designed for two-handed operation.
▶ Use only Hilti lithium­ion batteries of the B 18 / B 22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series with these batteries.

3.3 Possible misuse

▶ Do not use the power tool to cut bricks, concrete, cellular concrete, natural stone or tiles.
▶ Do not use the product to cut pipes that still contain liquids.
▶ Do not saw into unknown materials.
3.4 Lithium­ion battery status display
The charge status of the Li-ion battery and malfunctions of the power tool are indicated by the display on
the Li­ion battery. The charge status of the Li­ion battery is displayed after pressing one of the two battery
release buttons.
Status
4 LEDs light up.
4
Printed: 27.07.2016 | Doc-Nr: PUB / 5293021 / 000 / 00
1
)
+
§
/
:
Meaning
•
Battery
Rating plate
Forward gripping area (hand guard)
AVR contact shoe
Saw blade
Charge status: 75 % to 100 %