MS Schippers 440485 Mode D'emploi page 5

The heat mats cannot be covered with blankets, straw or any other materials. A heat blockage
must be avoided.
Damaged heat mats or cables cannot be installed. Any repair is to be done by a qualified
electrician.
Instructions for controller 4404857
Electric connection:
Max. outlet:
Temperature:
Installation:
FI-switch:
Installation
The controller must be mounted on a solid and not flammable surface. The enclosed plugs
that avoid the wires from being pulled out need to be fitted into the housing. The holes can
be drilled into the housing accordingly.
The electric installation must be done as shown on the plan, which is found inside the
controller.
The hook-up must be done by an electrician.
The controller can be adjusted starting at 25°C in steps of 1.6°C by pushing the '+' button.
Once you reach 40°C you can push again to get back to Zero.
Damaged controllers may not be used.
230V / 50Hz
1,800 W (including mother heat mat)
IP45, weight 480 gr.
adjustable 25°C – 40°C
only by an electrician
Installation of this switch is mandatory
5