Programming The Alert Mode; Home Mode; Programming The Home Mode; Technical Data - Schwaiger Green Guard Instructions De Service

USER MANUAL HG1000 532

8.2.1. Programming the ALERT mode

About the central unit:
Step 1
You must be in Standby Mode.
Step 4
Now press followed by the
button, in order to get into ALERT
mode.

8.3. HOME MODE

Basic setting in HOME mode
Sensor
Door/window sensor
Door/window sensor
Movement sensor

8.3.1. Programming the HOME mode

About the central unit:
Step 1
You must be in Standby Mode.
Step 4
Now press followed by the
button, in order to get into the
HOME mode.

9. TECHNICAL DATA

Remote control
Power supply
Operating frequency
Radio range
House security code
Step 2
Now enter "1-2-3-4"
newly set PIN
with .
(An additional beep gives acoustic
feedback as to whether the code
that was selected is right. - Three
beeps mean that the input was not
valid.)
Step 5
Now you can use the 1-8 buttons
to add or remove the relevant
zones.
(If no zone is shown, this is deac-
tivated)
Zone
1
2
8
Step 2
Now enter "1-2-3-4"
newly set PIN
with .
(An additional beep gives acoustic
feedback as to whether the code
that was selected is right. - Three
beeps mean that the input was not
valid.)
Step 5
Now you can use the 1-8 buttons
to add or remove the relevant
zones.
ZONE is in ALERT mode
ZONE is in ARM mode
ZONE is switched off
1 x 12V batteries (A27)
868.35 MHz (+/- 0.5 MHz)
Max. 60 m (open space)
Via 4-polar jumper
Step 3
or your If you enter the PIN correctly, the
and confirm this display now shows the following
image:
Step 6
Then confirm the selection using
switches into the Standby Mode
again.
Mode/Status
ALERT
ALARM
ALARM
Step 3
or your If you enter the PIN correctly, the
and confirm this display now shows the following
image:
Step 6
Then confirm the selection using
switches into the Standby Mode
again.
. The centre now automatically
. The centre now automatically
29