USER MANUAL HG1000 532
8.1.6. Setting zones
To programme the zones in ARM mode, proceed as follows:
Step 1
You must be in Standby Mode.
Step 4
Now press
followed by the
button, in order to get into ARM
mode.
8.1.7. Example of setting off an alarm
An alarm is set off in Zone 1.
Description
1
Activate ARM mode
2
Alarm is set off
3
Switch-on delay (30 seconds) Now the countdown timer runs for 30 seconds; in this time the system
4
Back to ARM mode after the
alarm has been set off
8.2. ALERT (signal) mode
When the system is set off, in this mode a beep sounds and the alarm centre flashes green every 2 seconds and
displays the zone that was triggered.
Basic setting in ALERT mode
Sensor
Door/window sensor
Door/window sensor
Movement sensor
28
Step 2
"1-2-3-4"
Now enter
newly set PIN
with
.
(An additional beep gives acoustic
feedback as to whether the code
that was selected is right. - Three
beeps mean that the input was not
valid.)
Step 5
Now you can use the 1-8 buttons
to add or remove the relevant
zones.
(If no zone is shown, this is deac-
tivated)
Note & description
can be deactivated without the alarm being set off (via the remote
control or the 4-digit PIN). If the system is not deactivated in this
time, an alarm sounds for one minute and the centre flashes red every
1.5 seconds.
After it is set off the first time, an alarm is set off again immediately
when further sensors are triggered.
Zone
1
2
8
Step 3
or your
If you enter the PIN correctly, the
and confirm this
display now shows the following
image:
Step 6
Then confirm the selection using
switches into the
Mode/Status
ALERT
ALERT
ALERT
. The centre now automatically