Setting The Alarm Display; Setting The Alarm Duration; Muting The Countdown; Deactivating The System - Schwaiger Green Guard Instructions De Service

USER MANUAL HG1000 532

8.1.2. Setting the alarm display

The standard setting for the alarm delay is 30 seconds. Within this time you can stay/move in the monitored
area without setting off an alarm.
This can be used, for example, to enter the house in quiet, without directly setting off an alarm. This alarm
delay can be set as follows:
Step 1
You must be in Standby Mode.
Step 4
Now press followed by the
button, in order to get into the
settings for the alarm delay.

8.1.3. Setting the alarm duration

The standard setting for the alarm duration is 1 minute. This means that in the event that the alarm is set off,
the alarm is set off for this time and scares off any intruders through a loud alarm noise.
Step 1
You must be in Standby Mode.
Step 4
Now press followed by the
button, in order to get into the
settings for the alarm delay.

8.1.4. Muting the countdown

If the alarm system is activated, a countdown timer sounds (as standard, this is 20 seconds, counting down-
ward). This can be muted by pressing the
activated again.
If the alarm system is activated in

8.1.5. Deactivating the system

In order to deactivate the system, either press the
system using the 4-digit code, followed by the
Step 2
"1-2-3-4"
Now enter
newly set PIN
and confirm this
.
with
(An additional beep gives acoustic
feedback as to whether the code
that was selected is right. - Three
beeps mean that the input was not
valid.)
Step 5
Now the set time delay is displayed.
"7"
(Factory settings: 30 seconds)
Press the "7" button as often as
you need to, until the duration you
desire is displayed.
(possible range: 10 seconds –
60 seconds)
Step 2
Now enter "1-2-3-4"
newly set PIN and confirm this
with .
(An additional beep gives acoustic
feedback as to whether the code
that was selected is right. - Three
beeps mean that the input was not
valid.)
Step 5
Now the alarm duration that you
"0"
have set is displayed. (Factory set-
tings: 1 minute)
Press the "0" button as often as
you need to, until the duration you
desire is displayed.
(possible range: 1 minute –
6 minutes)
MUTE button. By pressing the
ARM mode, the display flashes red every 5 seconds.
DISARM
button on the central unit.
Step 3
or your If you enter the PIN correctly, the
display now shows the following
image:
Step 6
Then confirm the set time using
. The centre now automatically
switches into the Standby Mode
again.
Step 3
or your If you enter the PIN correctly, the
display now shows the following
image:
Step 6
Then confirm the set time using
. The centre now automatically
switches into the Standby Mode
again.
MUTE button again the tone can be
button on the remote control or deactivate the
27