Commissioning The Window Sensor With Magnetic Contact; Commissioning The Movement Sensor; Commissioning The Remote Control; Assembly And Place Of Assembly - Schwaiger Green Guard Instructions De Service

USER MANUAL HG1000 532
The display has the following 4 divisions:
Full
High
Medium
Low
Note
In the case of low battery status the LCD display now flashes orange for 30 seconds and the
to flash. This symbol now flashes until the backup battery is replaced.

5.3. Commissioning the window sensor with magnetic contact

In order to commission the window sensors, open the lower cover of the product and place
(with the correct polarity) accordingly into the battery compartment here.
This product has a battery status display. As soon as a product's batteries must be replaced, the LED on the front
side of the product now slowly flashed red in resting condition.

5.4. Commissioning the movement sensor

Note
The movement sensor has an energy-saving mode for conserving the battery.
This means that the movement sensor switches into energy-saving mode for three minutes after the alarm and
does not send any further signals during this time.

5.5. Commissioning the remote control

To do this, carefully open the battery lid on the rear side of the remote control and then remove the transparent
contact breaker. Now the remote control is ready to then be integrated into the system (as described under Item
7.2. Adding the remote control).

6. ASSEMBLY AND PLACE OF ASSEMBLY

Alarm unit:
Window sensor with magnetic contact:
Movement sensor:
In order to commission the movement sensor, firstly remove the screw on
the lower side of the product. Now you can carefully remove the entire front
part.
Insert 1 x CR123A battery
battery compartment.
The sensitivity of this movement sensor can additionally be set.
For this, it has contact pins in the interior (on the right above the battery).
These are marked with H
m). Place what is known as the jumper (small black block) on the relevant
pair of pins (horizontal) for the setting you require.
Fastening with the help of screws
Fastening via glue pad or screws
Fastening with the help of screws
(with the correct polarity) accordingly in the
(High ≤ 13 m), M (Medium ≤ 8 m) or
symbol begins
2x AAA batteries
N (Low ≤ 5
21