General Information; Safety Information - Hach sc1000 Profibus DP/V1 Manuel D'utilisation De Base

Specifications
Specifications are subject to change without notice.
Specification Deatails
Profibus protocol Siemens ASIC SPC3
DP service DPV0 slave
DPV1 class 1 and class 2 slave
DP/DPV1 services I&M function
Address changing per Profibus master
9.6kBd, 19.2kBd, 45.45kBd, 93.75kBd, 187.5kBd,
500kBd, 1.5MBd, 3MBd, 6MBd, 12MBd
Profibus baud rates
Automatic baud rate detection
Indicators LED to display the data exchange mode
Interface type RS485
Data swapping, word wise for floating points
Configurable parameters
values
Dimensions (50 x 111.2 x 18) mm³
Operating temperature –20°C to 85 °C (–4 to 185 °F)
Operating voltage 8V–16V
Maximal power consumption 2W
Certification certified by Profibus organization

General information

Safety information

Please read this entire manual before unpacking, setting up or operating
this equipment. Pay attention to all danger and caution statements.
Failure to do so could result in serious injury to the operator or damage
to the equipment.
Make sure that the protection provided by this equipment is not
impaired, do not use or install this equipment in any manner other than
that specified in this manual.
Use of hazard information
D A N G E R
Indicates a potentially or imminently hazardous situation which, if not avoided, will
result in death or serious injury.
W A R N I N G
Indicates a potentially or imminently hazardous situation which, if not avoided,
could result in death or serious injury.
C A U T I O N
Indicates a potentially hazardous situation that may result in minor or moderate
injury.
N O T I C E
Indicates a situation which, if not avoided, may cause damage to the instrument.
Information that requires special emphasis.
Note: Information that supplements points in the main text.
Precautionary labels
Read all labels and tags attached to the instrument. Personal injury or
damage to the instrument could occur if not observed. A symbol on the
instrument is referenced in the manual with a precautionary statement.
This is the safety alert symbol. Obey all safety messages that follow
this symbol to avoid potential injury. If on the instrument, refer to the
instruction manual for operation or safety information.
English
English
0